You install a home battery in a dry, cool and ventilated room outside your living space and outside your escape route, such as a shed, garage or utility room. The fire department calls the shed the most fire-safe spot, with the garage and the attic as alternatives. Below you'll read for each room what works, what you're better off avoiding and what a battery requires.
Where is the best place to install a home battery?
It's best to install a home battery in a separate room that's dry, cool and well ventilated and that can be reached from the outside. Which room suits you also depends on the model, because home batteries vary quite a bit in weight, housing and how they're connected.
The Netherlands Institute for Public Safety (NIPV) advises against placing a home battery in living and occupied spaces, and recommends a room that emergency services can reach from the outside.
In most homes that leaves you with four spots: the shed, the garage, the utility room and the attic. A battery of just over 20 kilos is easier to get up to the attic than a complete unit of around 80 kilos.
Where may you install a home battery according to the fire department?
According to the fire department, you may install a home battery in a cool, ventilated spot outside your escape route, on or against a non-combustible surface. The fire department has separate recommendations for fixed home batteries and for plug-in batteries, but the requirements for the location are largely the same:
- Escape route: don't place the battery in the hallway, on the landing or under the stairs, so smoke doesn't block your way out.
- Detector: hang a working smoke detector in the same room; for a battery the fire department also recommends a CO detector.
- Surface: mount the battery on or against a non-combustible surface, such as a brick wall or a non-combustible base plate.
- Clear space: keep the area around it clear, don't place anything on the battery and don't put it under furniture, near the heating or in direct sunlight.
- Accessibility: choose a spot that you and the emergency services can easily reach.
- Stability: avoid spots where the battery can get wet, tip over or where you're likely to bump into it.
These requirements apply to every room covered below. If a spot fails on even one point, like a battery under the stairs, then look for another room, even if there's plenty of space.
Installing a home battery per room in and around your house
Installing a home battery works differently from room to room, because temperature, accessibility and the distance to your living space all vary. Below you'll find the rooms that are suitable in most homes and the rooms you're better off skipping. The attic gets its own explanation further on.
Installing a home battery in the shed
Placing a home battery in the shed is the most fire-safe choice, according to the fire department. A shed stands apart from your home, is often cool and well ventilated, and the fire department can reach it directly from outside.
Do have an installer assess whether the power cable to the shed can handle the battery's output. A detached shed is usually unheated, so choose a model that can handle the winter temperature and mount a smoke detector there.
Placing a home battery in the garage
Placing a home battery in the garage is a good alternative if you don't have a shed. A garage isn't an occupied space and often has its own door to the outside. Put the battery in a spot where you won't bump into it with your car or bike.
In an unheated garage, the winter temperature matters: according to the manufacturer, the Zendure SolarFlow Mix models and the Anker SOLIX Solarbank Max AC work down to -20 °C, but a Zendure battery only charges above 0 °C and first warms itself up with power in freezing conditions.
Placing a home battery in the utility room
Placing a home battery in the utility room or storage room is fine, as long as that space isn't your escape route. A utility room doesn't count as a living or occupied space and often has its own exterior door, which fits the NIPV advice for a space that's accessible from outside.
If your only exit runs through the utility room, or the outlet is on the same circuit as the washing machine, choose a different spot or a different outlet.
Can a home battery go in the meter cupboard?
No, a home battery doesn't belong in the meter cupboard, because most meter cupboards are too small and are located near the front door. That spot therefore falls within your escape route, where the fire department advises against a battery.
The meter cupboard does play a role: that's where the circuit the battery is connected to sits, and it's where, according to the fire department, you mark that there's a home battery in the house, along with the supplier's number.
Why not put a home battery in the basement?
Placing a home battery in the basement is not recommended, because according to the NIPV, flammable gases from a malfunction can actually build up in an enclosed space like a basement.
A basement is also hard for emergency services to reach and often damp. That makes the basement unsuitable, even if the temperature stays stable there all year round. The same consideration applies to a crawl space.
Why not put a home battery in the living room?
A home battery in the living room or bedroom doesn't match the advice from the NIPV, which excludes living and occupied spaces.
You spend most of your time in these rooms, including when you sleep, and a battery in a separate space gives you distance and time. The fire department also opts for a separate space like a shed or garage, rather than the spot where you sit every day.
Can you place a home battery in the attic?
Yes, you can place a home battery in the attic, as long as you take heat, weight and accessibility into account. The fire brigade mentions the attic as an alternative to a fixed home battery if you don't have a shed or garage.
For a home battery with a plug, the fire brigade prefers the ground floor, because the battery is more easily accessible there.
Heat is the first thing to consider. An attic under the roof heats up considerably in summer, while most models at TechPunt work up to 55 °C according to the manufacturers. An insulated and ventilated attic keeps the temperature more stable than an attic without insulation.
Weight is the second point. A Zendure SolarFlow Mix unit weighs around 80 kilos and an Anker SOLIX Solarbank Max AC 63 kilos, without extra batteries yet.
That unit has to go up the stairs and the attic floor has to carry the weight. A modular set, like the Zendure SolarFlow 800 Plus of just over 21 kilos with separate expansion batteries, you build up in the attic module by module.
Finally, don't put the battery by the attic stairs, because those stairs are your escape route down, and here too hang a smoke detector in the same room.
Place a home battery indoors or outdoors?
In principle, you place a home battery indoors or in an enclosed outbuilding such as a shed or garage. There the battery stays dry, out of direct sunlight and at a more stable temperature, and those are exactly the points the fire brigade mentions for the location.
Placing it outside is only possible with a model the manufacturer specifies for that. Zendure and Anker SOLIX call their models with an IP65 or IP66 housing suitable for indoors and for a sheltered spot outdoors, so even then you pick a spot out of the rain and direct sunlight. You can read what to watch out for with an outdoor setup in our guide on placing a home battery outside.
Where do you place a home battery with a plug?
According to the fire brigade, a home battery with a plug is best placed on the ground floor, in a space with a stable room temperature and close to a free, grounded outlet.
With a plug and play home battery, the outlet therefore helps determine where it goes, because the fire brigade advises against an extension cord or power strip. Also check the circuit in the meter cupboard that the outlet is on.
The fire brigade recommends no more than one home battery per circuit, and not a circuit you share with heavy appliances like the washing machine; a separate circuit is preferred. If the only suitable outlet is on a full circuit, pick another spot or have an installer set up a separate circuit.
How far can a home battery be from the meter cupboard?
A home battery can be placed away from the meter cupboard, as long as the power cable and the data signal bridge that distance. In practice, the cable length of your model and the range of your Wi-Fi determine how far you can go.
For power, Anker SOLIX gives you the choice of AC cables of 5 and 15 metres with a Wieland plug and a 15-metre cable with a Schuko plug, so the Solarbank fits even with an earthed socket further away.
A fixed connection on a dedicated circuit goes through an installer, who also assesses whether the cable to a shed or garage can handle the power. You'll find what you need for your setup in the home battery accessories.
For control, the signal matters. A P1 meter on your smart meter, like the Zendure Smart Meter P1, sends your consumption wirelessly, so the battery knows when to charge or discharge. That's why you should check at the chosen spot whether your Wi-Fi is strong enough.
Checklist for placing your home battery
With this checklist for placing your home battery, you can check in a few minutes whether a spot is suitable:
- Space: a shed, garage, utility room or insulated attic — not a living room, bedroom, basement or crawl space.
- Escape route: not in the hallway, by the front door, on the landing or under the stairs.
- Surface: firm, level and non-combustible, and strong enough for the weight of the complete set.
- Climate: dry, ventilated, out of direct sunlight and within the manufacturer's temperature range.
- Detector: a working smoke detector in the same room.
- Power: an earthed socket without an extension cord, on a circuit free of heavy appliances.
- Signal: enough Wi-Fi coverage for the app and the P1 meter.
- Notification: a note in the meter cupboard and a heads-up to your insurer.
If every point checks out, you've found a suitable spot for your home battery. If a spot fails on just one point, go back through the spaces above before choosing an alternative.
Which model suits the spot for your home battery?
Which model is the right fit depends on where your home battery goes, because every space has different requirements. An unheated garage or shed calls for a battery that can handle frost, an attic for a lightweight modular set you carry up module by module, and a spot far from the meter cupboard for a long connection cable and good Wi-Fi coverage.
At TechPunt, you can compare all home batteries from Zendure and Anker SOLIX side by side, with an IP65 or IP66 housing, expansion batteries you build up module by module, and connection cables up to 15 metres. Once you've picked your model, we ship it from our own warehouse in Barneveld.


